Reset
Manufacturer

Metal-Fab Temp Guard 18

Find information and product listings for 18 inch factory-built chimney system components in the Metal-Fab Temp Guard product line, with an emphasis on choosing the correct system. Temp Guard parts cover specialized factory-built chimney configurations; air-cooled and insulated versions must not be assumed identical.

Choosing the right item means verifying correct series, 18 inch nominal size, listed appliance application, fitting type, and mounting or termination requirements. The Metal-Fab Temp Guard label identifies a particular product family. Nominal size alone does not establish compatibility with other brands or other venting designs.

How to choose 18 inch Metal-Fab Temp Guard

When comparing 18 inch factory-built chimney system components in the Metal-Fab Temp Guard product line, identify the intended use before looking at part numbers and finishes. Temp Guard parts cover specialized factory-built chimney configurations; air-cooled and insulated versions must not be assumed identical.

Appliance and vent system

Stove connector, factory-built chimney sections, and liners used in an existing chimney are not substitutes for one another. This group is organized around 18 inch. Check whether the number refers to a single nominal vent diameter or, in concentric designs, a pair of passages; actual dimensions can vary by series. The Metal-Fab Temp Guard family is a useful way to narrow the search, but its joint style and approved accessories still need to match.

Venting layout and safety checks

A complete system may need more than a straight pipe section. Depending on the approved installation, review support hardware, turns, flashing, firestops, adaptors, cleaning access, and the appropriate termination. The permitted route and clearance to combustibles come from the appliance and vent manufacturer, not the category label. Match system variant, clearance listing, supports, and appliance approval. Determine where the system transitions from connector or liner to its listed chimney/termination arrangement, and account for structural support.

What to compare before ordering

  • Confirm the appliance manufacturer, model, fuel, and approved vent category or vent family.
  • Match 18 inch nominal dimensions, wall construction, joint design, and all required adaptors.
  • Review elbows, tees, supports, wall or roof penetrations, clearances, and termination instructions.
  • Check whether any transition or substitute component is explicitly authorized by the manufacturer.

Does Metal-Fab Temp Guard 18 inch work with any existing chimney?

Not necessarily. A factory-built chimney is a listed system whose joints, supports, and penetration accessories need to match the model family. Compare the approval and installation manual for the exact appliance.

When details are unclear, use the appliance rating label, model number, and manufacturer's instructions to confirm fit.