MHP Everglow GG2A Cast Aluminum Mount Gas Lamp Head Series - GG2A

Add simple elegance to your setting with the English countryside inspired the design of our GG2A lamp series. Four glass tempered panels are included.

• 22" H x 10-3/4" W
• Gas lamps and mantles are designed to be on 24/7
• Available in Natural Gas or LP Gas
• UL Listed

Click to see Everglow Gas Lamps and Torches Brochure

Click to see Everglow HK-GG-HJ Series Gas Lamp Owners Manual

Proper Lighting Instructions for Dual Inverted Burners
STEP 1: Remove the glass by lifting from the bottom with forefinger, pulling out slightly, and lowering. NOTE: Proper combustion is essential. Do not obstruct air inlet or outlet vents

STEP 2: WITH GAS TURNED OFF, hold a lighted match up to but not touching the mantle. This will burn off the protective coating (and it will flash slightly). Do not touch the mantle with the match.

STEP 3: After the mantles have stopped burning, use a screwdriver to slowly turn the gas ON and hold another match up to, but not touching, the mantles to light them. When lit, turn the gas on full.

STEP 4: Your MHP lamp is factory set to burn at its most efficient point. However, this adjustment may be changed during shipment. To adjust this, raise or lower the air shutter until the mantles are burning their brightest. Shutter opening should be approximately 1/16"

STEP 5: If flame extends above the ceramic mantle ring, turn off lamp valve and contact your local gas company or authorized MHP dealer. NOTE: Proper combustion is essential. Do not obstruct air inlet or outlet vents.

STEP 6: Replace the glass by fitting the top edge into the frame top, holding the glass against the tabs inside the frame. Allow the glass to slide into the frame bottom.

Proper Lighting Procedure for Open Flame Burners
STEP 1: Remove the glass by lifting from the bottom with forefinger, pulling out slightly, and lowering. NOTE: Proper combustion is essential. Do not obstruct air inlet or outlet vents.

STEP 2: Use a screwdriver to slowly turn the gas ON and hold a match up to the burner. When lit, turn the gas on full.

STEP 3: Replace the glass by fitting the top edge into the frame top, holding the glass against the tabs inside the frame. Allow the glass to slide into the frame bottom.

Various SKUs for this GG2A Series Lamp: GG2A-E, GG2A-N, GG2A-NO, GG2A-P, GG2A-PO

California residents please click on the link for information on Proposition 65 BEFORE purchasing.