DuraVent DuraChimney II 14
This category focuses on 14 inch factory-built fireplace chimney components in the DuraVent DuraChimney II product line, organized so you can compare the details that affect fit. DuraChimney II components belong to an approved chimney system and must match the fireplace or appliance listing.
Look beyond the product name: confirm correct series, 14 inch nominal size, listed appliance application, fitting type, and mounting or termination requirements. The DuraVent DuraChimney II label identifies a particular product family. Nominal size alone does not establish compatibility with other brands or other venting designs.
Understanding 14 inch DuraVent DuraChimney II
The details on this page concern 14 inch factory-built fireplace chimney components in the DuraVent DuraChimney II product line. DuraChimney II components belong to an approved chimney system and must match the fireplace or appliance listing.
Appliance and vent system
Stove connector, factory-built chimney sections, and liners used in an existing chimney are not substitutes for one another. This group is organized around 14 inch. Check whether the number refers to a single nominal vent diameter or, in concentric designs, a pair of passages; actual dimensions can vary by series. The DuraVent DuraChimney II family is a useful way to narrow the search, but its joint style and approved accessories still need to match.
Selection details that matter
- Confirm the appliance manufacturer, model, fuel, and approved vent category or vent family.
- Match 14 inch nominal dimensions, wall construction, joint design, and all required adaptors.
- Review elbows, tees, supports, wall or roof penetrations, clearances, and termination instructions.
- Check whether any transition or substitute component is explicitly authorized by the manufacturer.
Venting layout and safety checks
A complete system may need more than a straight pipe section. Depending on the approved installation, review support hardware, turns, flashing, firestops, adaptors, cleaning access, and the appropriate termination. The permitted route and clearance to combustibles come from the appliance and vent manufacturer, not the category label. Check the chimney system designation and approved elbows, penetrations, and terminations. Determine where the system transitions from connector or liner to its listed chimney/termination arrangement, and account for structural support.
Does DuraVent DuraChimney II 14 inch work with any existing chimney?
Not necessarily. A factory-built chimney is a listed system whose joints, supports, and penetration accessories need to match the model family. Compare the approval and installation manual for the exact appliance.
Compare the exact part number and product specifications before ordering a replacement or building a new system.




